Page 1 of 1

DR-MH200SEK HDD Cloning

Posted: Sat Jan 31, 2009 11:14 pm
by WDMDL
Having now got this machine working, I would like to clone the HDD.

Does the replacement HDD have to be the exact same model as the original (mine is a Seagate ST3160022ACE), or will any 160GB HDD be suitable?

I understand that the clone will have to be done in "raw" mode, due to the non-standard formatting.

Is Drive Clone 3 suitable, or can you recommend other suitable software?

Thanks,
Martin.

Posted: Sun Feb 01, 2009 11:27 am
by andywilks
I recently observed a different drive in a machine that I was hoping to clone from.

Sizes were slightly different so Ghost wouldn't do it.
I can't help feeling that if we could image most of the data onto the drive then it should work....Ghost won't let you...maybe another prog would.

As for exact make/model... earlier units had eeprom settings that required the exact drive...This may still be the case, but since Jvc are using a couple of different drives, they may have relaxed the need to lock the firmware to the drive type now. Worth a try. especially if you have a 160Gb slightly larger sectors etc.