JVC SR-DVM70 "Loading" problem
Posted: Fri May 28, 2010 10:38 pm
Hi,
After I have done some sucesfully restoring the machine back to live 2-3 times by writing the disk root image, found on these links ( see below), the machine was booting up ok, recording and power off.
Once I pull the plug, the problem is back again.
The HDD had some bad sectors on the end of the disk, where the bouncing JVC image is stored and some other stuff that I have erased by mistake. I do not know the offset where that info was starting, but was very small and was the only data on that part of the disk ( I used winhex to write the disk0001.bin image at the root of the disk and every time was working)
Please see this:http://forum.videohelp.com/threads/3212 ... ost1990038
I think the 160 GB image is the same in FW for the DR-MH30 HDD image.
If someone can load up the HDD thru USB cable and save with winhex the info at the end of the disk, it can try to restore my hdd from scratch.
Many thanks,
After I have done some sucesfully restoring the machine back to live 2-3 times by writing the disk root image, found on these links ( see below), the machine was booting up ok, recording and power off.
Once I pull the plug, the problem is back again.
The HDD had some bad sectors on the end of the disk, where the bouncing JVC image is stored and some other stuff that I have erased by mistake. I do not know the offset where that info was starting, but was very small and was the only data on that part of the disk ( I used winhex to write the disk0001.bin image at the root of the disk and every time was working)
Please see this:http://forum.videohelp.com/threads/3212 ... ost1990038
I think the 160 GB image is the same in FW for the DR-MH30 HDD image.
If someone can load up the HDD thru USB cable and save with winhex the info at the end of the disk, it can try to restore my hdd from scratch.
Many thanks,