repair or replace rx500b

Moderator: andywilks

User avatar
andywilks
Moderator
Posts: 147
Joined: Mon Jan 24, 2005 11:38 am
Location: Pendle Witch Country, Lancs

Post by andywilks » Thu Jul 17, 2008 11:15 am

Contrary to your thoughts, some dry joints often cannot be easily provoked by tapping, but instead only appear as the temp of the component increases and its legs increase in length as a result.

I can't remember, but if the bottom panel removes to give access to the soldering under the main amp board (next to the big alu h-sink), you may be able to inspect it yourself. Obviously don't have the unit plugged in, and leave it a few mins unplugged before working on it to allow the big caps to discharge.
If there is a small 3 inch square board stood vertically then the faulty soldering will be on that. See
Image

jadeli89
Posts: 1
Joined: Tue Sep 28, 2010 5:51 am

hello

Post by jadeli89 » Tue Sep 28, 2010 6:09 am

well, it think you need to avail your warranty this time..return that thing to where you bought it i suggest..don't you think? :oops: :lol: :lol:

Post Reply